Recent Repair Jobs

-
tacalimit de9015

tacalimit de9015 Repair

not sure it work when it wanted to but now stopped

-
Merrill maxitrol G30 ZR

Merrill maxitrol G30 ZR Repair

Doesnt appear to work or light up.

-
Rollertec PDT KF04-433RC RS0192SRD1e

Rollertec PDT KF04-433RC RS0192SRD1e Repair

Dead. No light.

-
CONCERN FOR COMFORT XL0394-260616

CONCERN FOR COMFORT XL0394-260616 Repair

Remote works intermittently

-
Carolina RCS-01C

Carolina RCS-01C Repair

Nothing works despite changing batteries

-
Gazco Mertik Maxitrol

Gazco Mertik Maxitrol Repair

Remote was knocked onto the floor and stopped working. Batteries both in the remote and the receiver have been changed to no avail.


-
Mertik Maxitrol Remote *1 and Receiver x 2 G30 - ZRHS and G30 - ZRRS x 2

Mertik Maxitrol Remote *1 and Receiver x 2 G30 - ZRHS and G30 - ZRRS x 2 Repair

Remote ceased to function - Batteries recently replaced

-
Powrtouch / Powrwheel Limited

Powrtouch / Powrwheel Limited Repair

Wire has come off terminal in battery compartment.

-
Unknown PDT KF04-433RC

Unknown PDT KF04-433RC Repair

This remote was fell and run over accidently and now light blinks by pressing any of 4 buttons but no signals.

-
Clos-o-mat

Clos-o-mat Repair

The remote is for the following piece of equipment - adaptive disabled toilet - references on side of toilet as follows TYPE: LIMA VITA AC 230V 50HZ 1PX4 1450W 6.3 A Boiler 1.7.1. OPa CLOSOMAT AG NO 09.00459.0703 CH-8424 EMBRACH Remote seems to have been involved in accident - possibly unintentional damage by service user. We are unsure how badly compromised remote is - how intact circuit board is etc.

-
Triton  Body Dryer

Triton Body Dryer Repair

all buttons not working

-
MERLIN M872

MERLIN M872 Repair

FAILED TO OPEN GARAGE DOOR AFTER FALLING APPROXIMATELY 3 FEET ONTO A MAT COVERED HARD SURFACEI


-
PDT KF04-433RC RS0192SRD1e

PDT KF04-433RC RS0192SRD1e Repair

Lower green button and grey button not working. Sometimes no button works.

-
Dimplex RC01-008

Dimplex RC01-008 Repair

No response with new batteries - old batteries had corroded

-
carver m606887

carver m606887 Repair

dosnt light up put new battery in

-
PDT KF04-433RC

PDT KF04-433RC Repair

Went through the washing machine. When batteries are reinserted sometimes works but then stops working after a short while

-
Portway Fire

Portway Fire Repair

I inserted a new PP3 battery BUT only the low flame button (bottom right) causes the yellow light to flash. All 3 remaining buttons do not cause the yellow light to flash.

-
Sarason

Sarason Repair

Remote control won't turn my bathroom to on? Light is on on the tv but nothing happens with the remote.


-
Garage Door RS0192SRD1e

Garage Door RS0192SRD1e Repair

Battery tag sheared off

-
Firmadoor

Firmadoor Repair

has been variable, now, it doesnt work at all. Tried new battery.

-
Hulsta Rumat

Hulsta Rumat Repair

Lifting some bed sections only and won't go back down, especially the headrest section.

-
Flambeau 335 Basket Fire 71106-800-101

Flambeau 335 Basket Fire 71106-800-101 Repair

Remote worked fine until Sunday when the wire to the battery came off the connector. Have tried to solder it back on, but now not working.

-
Keyton  Massage chair

Keyton Massage chair Repair

after the remote was dropped, it fails to power up. I've checked, and removed and reinstalled batteries numerous times. Normally, you turn the remote on, and the LCD screen powers up, then you push a button to select the type of massage. ... currently it is dead and does not power up. .. the chair itself works fine as i can push the limited range of buttons on the chair to turn it on or off.

-
Doyce Electronics Ltd Doyce Digital DE400

Doyce Electronics Ltd Doyce Digital DE400 Repair

The remote controller which is used to select functions on the analyser itself is no longer working. It has 32 buttons and none are working. The 9v battery power feed earth wire is broken from the PCB, but the remote stopped working prior to the wire breaking off. The remote control is of a very simple design internally and is from the late 1980's so hopefully will be a simple fix.


Page 1 : 2 : 3 : 4 : 5 : 6 : 7 : 8 : 9 : 10 : 11 : 12 : 13 : 14 : 15 : 16 : 17 : 18 : 19 : 20 : 21 : 22 : 23 : 24 : 25 : 26 : 27 : 28 : 29 : 30 : 31 : 32 : 33 : 34 : 35 : 36 : 37 : 38 : 39 : 40 : 41 : 42 : 43 : 44 : 45 : 46 : 47 : 48 : 49 : 50 : 51 : 52 : 53 : 54 : 55 : 56 : 57 : 58 : 59 :