Recent Repair Jobs-
Faber G30-ZRHS & G30-ZRRS Repair
I have a Faber remote control connecting to a Mertik Maxitrol G30-ZRRS receiver. I have renewed batteries in both devices. increasing heat functionality is fine but decreasing functionality doesn't work at all. LED on remote works but led on receiver is spasmodic on decreasing heat. I removed the circuit board from the remote to see if button was stuck but this isn't the case. The remote is tatty so i'm looking for a new item. If you cannot supply then can you repair the remote and provide a better casing?
mertik maxitrol G30 ZRHS 9V DC Repair
Not working... Light on remote ok but nothing on receiver unit
QNAP NMP 1000 Repair
After being dropped the unit no longer activates the media player, the media player is operational by manually pressing the buttons on the player itself.
Focal Point MERTIK MAXITROL G30 ZRHS0 Repair
I can see the red light come up when buttons are pressed on the control but cannot see light coming of in the infra bulb in front of the control.
Bose Rc28t1-40 Repair
New house came with system and when moved in remote was not working. Some old battery's in remote looked that they may have leaked replaced and still not working.
Proclaim HE KPHLxxRN Repair
Loose wire inside the case. No writing on the screen of the remote control. Cannot turn fire on, off or anything at all.
Nederman 520129e Repair
this unit has a chip for it to work, if we put chip in other unit is will work so must be the handset as other one works for the other side of the handset.
Metric Maxitrol Repair
Response Electronics Plc HA50R Repair
Will no longer arm or dis-arm the system. We have another remote of the same type which works ok so we know the system itself is working & it is this remote that has failed.
Telestyrelsen ALR 9446 - not functioning Repair
magiglo g30 Repair
remote works but receiver doesn't. reciever has had battery leakage in the pass but have manged to get it to work for a few years now
Kenwood RC-28 Repair
It is quicker to say that the only button that appears to work is the Power.
MERTIK MAXITROL G30-ZRHDO Repair
FIRE NOT RESPONDING TO ANY OF THE CONROL BUTTONS BEING PRESSED
Mertik Maxitrol - Hunter Stoves G30-ZRRS Repair
The unit works on flame up.But will not work on flame down. The receiver light blinks on flame up but not on flame down.
MERTIK MAITROL G30-ZRPSO Repair
BATTERIES LEFT IN REMOTE AND HAS CORRODED THE BLACK WIRING.
Technika Ipod Dock - Hifi Repair
nothing working from remote new battery's etc still nothing
Valor URTC203 Repair
receiver will not toggle up or down to increase or decrease amount of propane coming in to regulate flame.
Mertik Maxitrol G30 - ZRHD Repair
I dropped the remote on a hardwood floor and it is no longer working, I've swapped the batteries on the remote and receiver but no joy. It still works when held up very close to the receiver (within an inch) so i suspect the transmitter on the top of the PCB inside is damaged
Brake Tester RC02A Repair
NOT WORKING AT ALL. TRIED NEW BATTERY NO GOOD. YOU MIGHT HAVE HAD THIS ONE BEFORE AS YOU HAVE DONE A FEW FOR US BEFORE. SORRY CANT GIVE ANY PROPER DETAILS
Gazco G30-ZRHT Repair
The remote control was working fine until someone has either dropped it or run over it with a Hoover. It worked completely normally after that for a couple of weeks although I could feel that the casing was coming loose. Then one day the casing came apart and the buttons popped out of their slots and I could not make them all go back into the correct places. So, as far as I'm aware, the remote has not broken mechanically, it just came apart a little while after being dropped.
mertik maxtrol g30 zhrso Repair
The remote will turn the fire on and up but not down and off. i have tried another identical remote for another fire in another room and it works perfectly on the fire in question and also tried the faulty remote on the other fire where it will again turn the fire on and up but not down and off
not working at all changed batteries no luck it sounds like something loose inside
Marantz RC003PM Repair
I forgot to take the batteres out and they Leaked corroding the batterers terminals.so can no longer put batteres in remote.
truma mover m120988 Repair
the remote control will not switch on and before it 'lay down' completely it was increasingly flickering the green light !