Recent Repair Jobs-
No Response from remote
MERTIK MAXITROL G30ZRHSO Repair
The remote will not operate the increase flame function to the receiver ( No flashing light on receiver. It will operate the flame reduction side of the operation,(Flashing light on receiver shown)For both operations on the remote, the red light comes on, but the receiver light only flashes during the flame reduction operation.
Mertik G30-ZRRS / G30-ZRHSO Repair
Fire turns on and increases output ok but very slow and temperamental to decrease
Mertik Maxitrol G30-ZRRS Repair
The LED illuminates on the remote control however the receiver LED light does not and therefore neither does the motorized valve operate.However if you touch the ultrasonic detector on the receiver all seems to be ok....
mertik maxitrol Repair
remote control not working
GAZCO MMB22600 Repair
LEAKING BATTERY RUSTED BATTERY CONNECTIONS IN BATTERY COMPARTMENT
mertic maxitrol G30 - ZRHSO Repair
will not turn on light or operate light ot motor on fire unit, Relative has similar fire and remote and this relatives remote operates the fire normally. Got friend tv repair man to look for obvious defect on remote and he thinks the chip in handset is gone faulty.
Verine Fireplace Repair
Intermittent fault with the buttons Main problem is with the top left button which has the worst problem but the other buttons occasionally refuse to function
Magiglo Elite - Merik Maxitrol G30 - ZRRS Repair
The receiver not working, if I flex the board it works.
BOSE RC28T1-40 Repair
Buttons need to be pressed hard, sometimes more than once to work. Also remote seems to lees "powerful" i.e. doesn't seem to work from as far away as originally and seems to have to be directly facing system, doesn't seem to work when at an angle to the system.
Mertik Maxitrol G30-ZRRS - receiver doesnt respond Repair
The remote seems ok, but the receiver even with new batteries doesn't respond,. Its light rarely comes on even when the remote is inches away
Mertik Maxitrol G30ZRHS Repair
The fire works correctly manually and the red light on the remote also works but it appears that the two do not recognise each other as there is no response from the fire. The battery in the remote is new as are the batteries in the fire.
Pangu D.L.S.B Magic Trick Repair
Remote Control does not function and insides of equipment base is loose
Gazco EL0239 Repair
Does not light fire after being dismantled by elderly owner! - "fish-eye" appears to be floating unattached at one side.
Samsung AH59-01159K Repair
The remote has been tested by 'firing' at a digital camera and no LEDS light.
mertic maxitrol g30-zrrs Repair
remote only works switching fire off or decreasing. Will not switch fire on or increase.
Vibradorm Bed Repair
Broken battery terminal
verine vesta variant Repair
Buttons are intermitant and often dont work at all. The connector for the 9v battery has had a temp poor repair
Vito Vital HB73-036 Repair
cable outer sheath damaged
Vibradrom 00.103.247 Rev 2.0 / 24.10.2005 Repair
Mertik Maxitrol G30-ZRHS Repair
This remote is a job lot of 2, the fault was no signal at all being sent by the handset
Mertik Maxitrol Gazco G30 Repair
Up button on remote lights LED and is received by the receiver as normal. Down button lights LED on remote but NOT on the receiver and the motor does not operate to turn down the gas supply.
Aircon Pn435620 Repair
The controller has stopped working
Verine Fireplace Repair
Internal wires are detached from fastener for the battery